predator g6-710 quick change hard drive not detecting

BENJI897
BENJI897 Member Posts: 2 New User
edited February 15 in 2018 Archives
i have a  g6-710 Ive put a HDD in the quick swap expansion bay but i cant seam to detect it any ideas i can hear it spinning up when i start the system Im stumped 

Best Answer

  • billsey
    billsey ACE Posts: 31,454 Trailblazer
    Answer ✓
    Take a look inside and verify the SATA and power from the back of the module are connected properly. It's possible the SATA side isn't connected. It's also possible the drive just has no yet been initialized. In that case it'll show up in Disk Manager but not as a drive letter.
    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.

Answers

  • billsey
    billsey ACE Posts: 31,454 Trailblazer
    Answer ✓
    Take a look inside and verify the SATA and power from the back of the module are connected properly. It's possible the SATA side isn't connected. It's also possible the drive just has no yet been initialized. In that case it'll show up in Disk Manager but not as a drive letter.
    Click on "Like" if you find my answer useful or click on "Yes" if it answers your question.
  • BENJI897
    BENJI897 Member Posts: 2 New User
    thanks was in disk manager