XB1 Acer feedback

Fleetz
Fleetz Member Posts: 1 New User

Looking at the new XB1 monitor info with the view of purchasing when they are available.

 

My application is running these in triple configuration however I see a potential issue in doing so. I noticed that the plastic protruding escution down the bottom is likely to cause the monitors not to butt up and allow the adjacent monitors bezels to "kiss" ? Thereby allowing a small gap I between the monitors. 

 

Typically the adjacent monitors are going to be angled at between 45 to 60 degrees. 

 

I could be mistaken as it is not easy to visualise from the photos on your website how far that horizontal bottom escution panel protrudes and if it will impact on the adjacent monitors ability to snug the bezels together without leaving a gap?

 

Appreciate if your Acer team could look into this and feedback if what I am suggesting may be an issue or not. I know in my application and the IRacing community this new monitor is going to be of great interest and will want the bezels snugged up in triple configuration.

 

Hopefully I have miss read the photos but it does look like you might struggle to get the monitors snugged up?

 

Fleetz