Acer Aspire Easystore upgrade HDD

Options
pete-w
pete-w Member Posts: 2 New User

Hi All

 

I have an Acer Aspire Easystore nas. Currently it has 4 Seagate 250gb hdd under a raid 5 config.

I have run out of space (+/-650 gb) This has been great for the last few years so I am thinking

about upgrading.

I have prevoiusly upgraded the firmware to V2.5 and in the readme file for that it says:

> 1. Add support for single volume size over 2TB.

 

Has any one put 4 * 2tb disks into one of these?

I am thinking of Seagate Barracuda ST2000DM001

Any tips or hints welcome?

 

Thanks

Peter

Answers

  • philetus
    philetus ACE Posts: 4,759 Pathfinder
    Options

    http://community.acer.com/t5/Servers-Storage/Acer-Aspire-Easystore-HDD-Fail-replace-upgrade-HDD/m-p/370519#M622

     

    searching I found lots of references to Western Digital Red NAS hdds,Seagate Barracuda ST2000DM001 and some WD greens, in the Acer.

     

     

  • IronFly
    IronFly ACE Posts: 18,413 Trailblazer
    Options

    go for WD red NAS version.

    I'm not an Acer employee.
  • pete-w
    pete-w Member Posts: 2 New User
    Options

    Hi All
    As a general note for all out there on my experiances with trying to
    upgrade the Acer Aspire Easystore with 2TB Seagate Barracuda
    ST2000DM001 drives.
    (Q: Why Seagate Barracuda ST2000DM001? A: I could get then cheap)

    I had prevoiusly upgraded the firmware to V2.5
    see:
    ftp://ftp.support.acer-euro.com/storage/aeasystore/fw/

    When I installed the HDD they were regonised as 2TB each. However
    it would just not format would just go to 94% and stop. I did set
    the time out to 600 min in case it was powering down while formating
    and left it to format overnight. I tried formating as raid 5 and
    JBOD but it did not work.

    I found this:
    http://forums.whirlpool.net.au/archive/1058603
    It is long and old but it had some some usefull hints.
    I downgraded the firmware and even did a reset to factory.

    When I downgraded I could format (it took quite a while +/-4 hours)
    but it would not read the full size of the HDD. And I ended up with
    about 1.3TB on raid or 1.8 TB on JBOD.

    I then when down the whole accessing the root of the system to
    EG: http://dns323.kood.org/howto:fun_plug

    I finally got to the state, with firmware 2.1, that there was a
    raid 5 on the box (5.8 TB total), when I accessed it via telnet,
    but I could not share the volume or access it via the easystore
    web interface.

    I am sure if I tried more I could probably get it to work but
    right now it's just not worth more of my time.
    I will leave that to braver souls.
    Regards
    Peter