My ACER ASPIRE 4551G won't boot

markmaraya
markmaraya Member Posts: 11 New User
edited March 2023 in 2015 Archives

When I try to turn it on I'll just get a black screen. The fan will start but will stop eventually. When I try to hard reset it it won't turn off the fan will just start again. I have to plug out the AC so I can be able to power it again. And also last thing I remember is that the clock is not always on sync whenever I start it. Please help! Smiley Sad

Best Answer

  • laurent_14
    laurent_14 ACE Posts: 10,359 Trailblazer
    Answer ✓

    Hello,

     

    You have probably a DC connector issue. I suggest you to clean it after removing the battery.

    France

Answers

  • Hello,

     

    You wrote:

    "And also last thing I remember is that the clock is not always on sync whenever I start it?"

    The CMOS battery voltage is too low. You have to change it.

     

    Have you tried to connect it to an external monitor?

    France
  • markmaraya
    markmaraya Member Posts: 11 New User

    Thank you for your reply. So replacing the CMOS will solve the clock issue.

     

    About the extrenal monitor is it for checking if my screen is working?

     

    The screen is working. I'm using it right now. But when I shut this down It will be hard to boot again.

  • Hello,

     

    The replacement of the CMOS battery will solve the date and boot issues.

    About the extrenal monitor is it for checking if my screen is working? Yes.

    France
  • markmaraya
    markmaraya Member Posts: 11 New User

    I have replace the CMOS battery with new one and it did'nt solve the boot issue.

     

    Before I replace the CMOS it has a chance of starting up. When I hold down the power button and the lights turns on and when the lights goes off after a few seconds of holding down the power button it will successfully boot the next attempt. And when the lights won't go off after holding down the power button it will not boot.

  • Hello,

     

    Have you already changed the battery or/and the AC adapter?

    Is it the original battery?

    France
  • markmaraya
    markmaraya Member Posts: 11 New User

    I'm not using the battery. I'll try using other AC if i found one. Thanks!

  • markmaraya
    markmaraya Member Posts: 11 New User

    I tried a different AC and I get the same result.

  • Hello,

     

    The date is it always "wrong"?

    Could you give me the actual bios version?

    I think the bios is corrupted.

    France
  • markmaraya
    markmaraya Member Posts: 11 New User

    The date and time sync is fixed now after I replace the CMOS battery with a new one.

     

    The BIOS version is v1.09

  • Hello,

     

    You can flash the bios with the version 1.11 (1.09 unavailable on the Acer website).

    Flash only the bios under DOS. If you need a procedure, tell me.

    France
  • markmaraya
    markmaraya Member Posts: 11 New User

    Yes can you tell me how to do it. Thanks!

  • Hello,

     

    I give you the procedure to flash your bios under MS-DOS (Aspire 4551G - Bios 1.11):

     

    To flash the bios under MS-DOS:

     

    1- Make a DOS Bootable USB Flash Drive (see note) with HP USB Disk Storage Format Tool

    2- Download the bios folder zipped and unzip it.

    3- Copy all files and folders on the USB flash drive.

    4- Boot on the USB flash drive (see the note).

    5- When you are under MS-DOS, type the command BIOS.BAT

    6- If it's flashing successfully, reboot your system (normally, it reboot automatically).

    7- Enter on the bios setup utility, "Load optimazed defaults" or "Load default settings"

    8- Save and Exit

     

    --- If you have a doubt, do not hesitate to ask me questions ---

     

    In you case when you'll be in the boot menu [F12], wait one minute to see if your laptop is stable.

     

    Note:

    HP: By default, Letter C --> you'll see it like a HDD or USB HDD

    USB Flash Drive: 2Gb maxi

     

    You can also use Rufus (IronFly info) - Select MS-DOS - Watch this video.

    France
  • markmaraya
    markmaraya Member Posts: 11 New User

    After step 5 I will get a message that says "DC Does not exist!"

  • Hello,

     

    In BIOS.BAT:

    echo Notice:
    echo 1. This procedure may replace your BIOS!
    echo    If you don't want to do it, press Ctrl-C to cancel.
    echo 2. Make sure you plug in the AC adapter before flashing BIOS.
    echo    If not, DO NOT flash!
    echo 3. This utility will check if the battery capacity is over 30%.
    echo    If not, it will stop to flash the BIOS.

     

    You had written:

    "I'm not using the battery. I'll try using other AC if i found one. Thanks!"

     

    Have you installed the battery?

    France
  • markmaraya
    markmaraya Member Posts: 11 New User

    Yes I've put back the battery and able to update the BIOS to v1.11

     

    And still the problem exist.

     

    When the AC is connected it won't boot.

    And if I put the battery and AC together it still won't boot.

    But when I remove the AC and leave only the battery it will start up normally.

  • laurent_14
    laurent_14 ACE Posts: 10,359 Trailblazer
    Answer ✓

    Hello,

     

    You have probably a DC connector issue. I suggest you to clean it after removing the battery.

    France
  • markmaraya
    markmaraya Member Posts: 11 New User

    Thank you so much! Smiley Happy

  • laurent_14
    laurent_14 ACE Posts: 10,359 Trailblazer

    Hello,

     

    Have you cleaned the DC connector with a contact cleaner spray?

    Does your laptop working properly?

    France
  • markmaraya
    markmaraya Member Posts: 11 New User

    Yes it is working properly now. Thanks for all the help.

  • Afzal
    Afzal Member Posts: 1 New User

    To laurent_14 I have tried to private message you but i have been unsuccessful in doing so, please could you kindly message me. Thank you and have a great day.