iconia w3 810 touch screen not working after flashing bios

HUNTERZ

MY SPECS ARE IN SIGNATURE IF NEEDED 

 

After getting newest update of BIOS for my tablet (LISTED BELOW) about two days after doing that i found the BIOS update file and didnt know what it was at first (the name of the file was CHEETA but the end was cut off) so i tapped on it and it rebooted my computer and said, '' initializing flash bios '' (by then i thaught i was going to screw it up if i installed it again). So i rebooted my system and thats when it happend. Plain and simple my touch screen wasnt working so i went into device manager and looked there and there was a system bus that had a yellow exclaimation mark over the image. [I dont know if that system bus had anything to do with the touch screen but it said that the device wasnt working properly because of a power issue]

 

Thx, HUNTERZ

billsey

Try removing the device through device manager then rebooting to allow the system to reinstall. That often fixes driver problems.