Desktops & All-In-Ones

[narso]

Hi

I am new in the forum so sorry for anything that i will so wrong.

i have a pb with a acer x1300, when powered everything run, fan, cd, light on keyboard but no display no bit.

after swaping all the part for known working one, i got a new motheboard but still the same pb, having gone

through the forum answers i will test the only part i did not test, the power supply as i was getting some power

i did not check it

i will appreciate any suggession and help for resolving this issue as i said i have exhausted all options , i thank you

in advance

[IronFly]

you didn't get acer logo on boot or BIOS pressing F2 at boot?

[narso]

thank for your question. i did not get anything on the screen , the two monitor i have tried just turn themself in saving mode

[IronFly]

Ok

this can be a VGA issue, since the 2 monitors can't find any signal.

have you checked PSU connectcion to VGA?

have you tried different VGA-Monitor cables?

[narso]

yes swap the cable still the same tried an pci graphic card still the same output, ihave same pb with a different motherboard that i just received this weekend , i just tried a 300 w power suply and i notice that the cpu fan runs a bit faster but still no display

i banging my head against the wall

[IronFly · Accepted solution]

can you write the exact model?

x1300-xxxx

by the way i would try with a 450w at least.

[narso]

it is a acer aspire x1300, AMDX3 82550, 3GB. 32OGB,8200 integrated NVDIA GForce

the two motherboards are original DA061/078L and the second one 078L/07160 they both are exactly the same

after grounding i just had to swap the cable and parts.

i will go fetch a bigger power supply and a pci graphic card as the one i used was a agp one

ta

[IronFly]

Before spend money, let's check other things.

disconnect HDD-DVD and mount only 1 stick of ram if you got 2.

now disconnect the PSU from the wall plug, open PC case and take off the internal battery.

wait 5 minutes and press power button twice, just to discharge completly the motherboard.

now put back the internal battery, plug the PSU cable and try to boot without connecting DVD/HDD and with only one stick of ram.

[narso]

TOP TOP MAN!!!!!!!!

did what you suggested and there"was light and display", then i restarted the system with hdd and cd then still ok

but after adding the second ram the system repeat the no display pb . removing that ram was the solution

i remember removing both ram not one at the time when checking that was my mistake ..

thank you a thousand time and keep it up ACE IronFly i learned a great deal today

[IronFly]

You welcome.

now it's time to buy some sticks of good ram.