Bios Update Message: "FLASH PART NO SUPPORT"

TomPat · ‎01-04-2014

Veriton M670G Windows 7 Pro.

Downloaded BIOS update from Acer site for this system.

Attempted to update BIOS from P01-A3 to R01-A4 in DOS via USB flash drive.

1st flash try - Seemed to flash ok then on reboot "checksum bad." Loaded BIOS using F1, forgot to load default setting. Then rebooted to windows ok, but still showing P01-A3.

2nd flash try - "bootable checksum ok", "module chekksum ok", then "message: flash part no support." Loaded BIOS and this time loaded default setting.

Boots to windows ok, but still showing P01-A3.

Not sure what that flash update message means. Since Windows loads, am I better off forgetting R01-A4?

Acer-Tommy · ‎01-13-2014

Why are you attempting to flash the BIOS?

You may find this article helpful:
BIOS Update frequntly asked questions

Important Links: Global Support Pages | Knowledge Base Articles
Remember to mark posts that resolved your issue with Accept as Solution. You can even mark multiple posts in a single thread. This will make it easier for others to find the same information. Use the Give Kudos button to offer a thumbs-up for good post content and a pat on the back to the author.

Desktops & All-In-Ones

Tema

Bios Update Message: "FLASH PART NO SUPPORT"

Re: Bios Update Message: "FLASH PART NO SUPPORT"

Bem Vindos

Você sabia?