如何設定iSCSI跟網路孔對應的設定?
Ans:請參考以下步驟設定.
a. 請在開機POST過程中按下CTRL-D ,然後你會看到以下資訊
Intel (R) iSCSI Remote Boot version 2.7.97
Copyright (c) 2003-2011 Intel Corporation. All rights reserved.
Press ESC key to skip iSCSI boot initialization.
Press to run setup...
b. 請選取你想要設定iSCSI功能的網路孔.
c. 請選取 iSCSI Boot priority去設定特定的網路孔
d. 請設定iSCSI 開機設定如下
以下為例題
========== iSCSI Boot Configuration ==========
[ ] Use dynamic IP configuration (DHCP)
Initiator Name: iqn.2008.com.ac
Initiator IP: 192.168.10.50
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
VLAN ID:
[ ] Use DHCP for iSCSI Target information
Target Name: iqn.1994-04.jp.c
Target IP: 192.168.10.201
Target Port: 3260
Boot LUN: 0
Press spacebar to change
[OK] [Cancel]
e. 以上設定後就存檔離開並重開機
設定後,重開機的過程中將會看到以下資訊
Intel (R) iSCSI Remote Boot version 2.7.97
Copyright (c) 2002-2011 Intel Corporation. All rights reserved.
Press ESC key to skip iSCSI boot initialization.
Linking up adapter port – MAC address(0015176C7958).
Using STATIC configuration for primary port, please wait.
iSCSI Target Name : iqn.1994-04.jp.co.hitachi:rsd.d8a.t.11363.0a000
iSCSI Target IP Address : 192.168.10.201
LUN ID: 0 Port: 3260
iSCSI Initiator IP : 192.168.10.50
iSCSI Gateway IP : 0.0.0.0
iSCSI Initiator Name : iqn.2008.com.intel:r920iscsi
Attempting to connect to target disk using MAC address(0015176C7958)
LUN: 0 DEVICE: HITACHI DF600F 40.0 GB
