請在開機時按下F2進入BIOS設定
a. Please load default BIOS settings.
b. Please select Advanced.
c. Please select IDE Controller.
d. You might see below information:
Onboard PATA Controller [Enabled]
Onboard SATA Controller [Enabled]
SATA Mode [Enhanced]
Configure SATA as RAID [Disabled]
e. By selecting Configure SATA as RAID, please choose Enabled to enable the onboard SATA software
RAID. Then, you would see more options.
Configure SATA as RAID [Enabled]
SATA RAID OPROM [LSI]
f. Altos G330 support dual SATA software RAID stacks, i.e., Intel & LSI Logic. By default, the RAID stack
is LSI Logic which supports RAID 0, 1, 10. If you want to support RAID 5 as well as RAID 0, 1, 10, you
must use Intel RAID stack. This can be done by selecting the SATA RAID OPTOM and choose Intel
Matrix Storage.
SATA RAID OPROM [Intel Matrix Storage]
NOTE. Different RAID drivers are required for different RAID stack.
g. Please press F10 to save your setting before exit from BIOS Setups
