詳細說明：當Altos G530實際安裝4G記憶體，但作業系統中卻無法顯示出4G
解決方法：
Altos G530之晶片為E7320，本身最大能顯示出3.37G，若顯示低於3.37G的狀
況下有以下兩種方式可進行調整
1.若是以下作業系統，可使用PAE參數修正
‧ Windows Server 2003 Enterprise Edition
‧ Windows Server 2003 Standard Edition
‧ Windows 2000 Advanced Server
On Windows 2000 Server, the system still reports 3.37 GB of memory when PAE
mode is enabled.
PAE參數設定方式：
可參考以下附件檔案操作說明
亦可參考微軟 KB ID：888855及 ID：838765
2.BIOS更新至P03以上版本
並在BIOS內進行以下設定修改：
a. Please enter BIOS Setup by entering F2 during POST.
b. Please select Advanced.
c. Please select Memory Configuration.
d. You would see below options:
DIMM 1A [Installed]
DIMM 1B [Installed]
DIMM 2A [Installed]
DIMM 2B [Installed]
Extended Memory Test [Disabled]
Memory Retest [Disabled]
Memory Remap Feature [Enabled]
Memory Sparing [Disabled]
e. Please select Memory Remap Feature and choose Disabled.
f. Please press F10 to save your setting before exit from BIOS Setup.
注意： You only need to disable this Memory Remap Feature when
PAE (Physical Address Extension) mode is not enabled.
