適用機種: Altos 1200, Altos G300, Altos G301, Altos G310, Altos G310 MK2, Altos G320, Altos G330, Altos G330 MK2, Altos G510, Altos G520, Altos G530, Altos G5350, Altos G540, Altos G540 M2, Altos G5450, Altos G700, Altos G701, Altos G710, Altos G900, Altos G901, Altos R300, Altos R310, Altos R510, Altos R510 MK2, Altos R520, Altos R520 M2, Altos R5250, Altos R700, Altos R701, Altos R710, Altos R720, Altos R720 M2, Altos R910, Altos R920, Altos S200F, Altos S205F, Altos S300, Altos S700, Altos S700F, ARMC, ARMC_2, ARMC_3P, SAS HBA, SCSI HBA
Lsi Logic MegaRAID SAS 8300XLP 會記憶原硬碟RAID 設定,因此當相同的硬碟被抽換(移除或是接上)時，這張RAID Card因為已經記得此款硬碟，故不會自動進行Rebuild動作,此為LSI Logic MegaRAID SAS 8300XLP之設計。
通常一般會自動做rebuild的狀況是發生在:
‧在規劃RAID時,有建立一顆Hot Spare的硬碟
‧當RAID有硬碟壞掉時，換上一顆全新的硬碟或是未被設定過RAID的硬碟
因8300XLP不會自動Rebuild,故請如下步驟讓硬碟進行rebuild
1.重新開機進入SAS ZCR Web BIOS Utility(Ctrl-H)
2.把新接上去的硬碟狀態從UNCONFIG BAD改成UNCONFIG GOOD
3.以上步驟完成後,系統將會進行Rebuild
Note:這些動作無法在MegaRAID Storage Manager軟體執行
