You can use the Predator Connect W6 router to set up and run a WAN. Supported connection modes are:
- Dynamic IP
- Static IP
- PPPoE
- Switch WAN port to LAN (switch/bridge mode).
You will need to go into your WAN Settings menu and enable the appropriate connection mode using the steps below:
- Open your web browser.
- Type http://acerconnect.com:8080 or http://192.168.76.1:8080 into
the address bar and press Enter. - Enter the Admin password from the label on the bottom of the router, or your admin password if you have changed it.
- Click on WAN and set your connection mode.